Skip to navigation – Site map

HomeNuméros33 (suppl.)Methods and innovationsData Processing and Image Enhance...

Methods and innovations

Data Processing and Image Enhancement of GPR Surveys of Roman Villas in Austria

Alois Hinterleitner, S. Seren, Klaus Löcker, Wolfgang Neubauer and E. Bayirli
p. 299-302

Full text

Introduction

1The quality of ground penetrating radar data can suffer from many different sources of noise. Some of these sources are varying distances of the antennas to the ground due to rough surfaces, different surface conditions (e.g. compression due to tractor tracks), external electromagnetic fields and instrumental noise and instabilities (Seren, 2007). Analyses of recorded raw data and knowledge of the source of noise lead to specialised processing methods to improve the signal-to-noise ratio and to enhance the archaeological structures in depth-slice visualisations. These methods are applied to three GPR survey data-sets of Roman villas in Austria, showing clear archaeological structures but suffering from very bad surface conditions.

Roman Villa Halbturn

2The Roman villa of Halbturn (Daim, 2001) was prospected in September 2000 using a Sensor and Software PulseEKKO 1000 system with 900 MHz antennas. An area of 100 x 100 m was surveyed with a spatial resolution of 0.5 x 0.05 m (804201 traces). The data are very noisy because of instrument noise and instabilities of the old PulseEKKO 1000 system, and because of the rough surface due to ploughing.

3Standard pre-processing methods (removal of DC-shift and depth-depending amplification (AGC)) lead to very noisy visualization (Fig. 1a, 2a). Detection and removal of erroneous traces and application of well known pre-processing methods like high-pass-filtering (removing frequencies below 450 MHz) (Fig. 1b, 2b) and background removal (Fig. 1c, 2c) or both (Fig. 1d, 2d) lead to much better results. Visualising only frequencies between 900 MHz and 1800 MHz (Fig. 1e, 2e) enhances the visibility of the archaeological structures compared to the method in Fig. 1d. Applying a background removal filter algorithm where the length for computing the average trace is limited to 1 m removes a lot of striping patterns in the direction of the GPR profile by widening the archaeological structures a bit and leading to the best visualization for subsequent archaeological interpretation (Fig. 1f, 2f).

Figure 1a-f: Visualisation of a part of corresponding radargram (length: 14 m; time: 30 ns).

Figure 1a-f: Visualisation of a part of corresponding radargram (length: 14 m; time: 30 ns).

a) without special pre-processing; b-f): removing erroneous traces; b) removing frequencies below 450 MHz; c) background removal filter; d) removing frequencies below 450 MHz and background removal filter; e) band pass filter (900 MHz-1800 MHz) and background removal filter; f) band pass filter (900 MHz-1800 MHz) and removal of average trace of 1m length.

4Figure 2 show the effects of the different methods described above for a part of the radargram. Fig. 2a shows the raw data. In fig. 2b “horizontal” patterns are still visible after high-pass filtering and in fig 2c “vertical” patterns are still visible after the application of a background removal filter. In Fig 2d these patterns disappear after applying both high-pass filtering and background removal. A band-pass filter (900 MHz – 1800 MHz) together with a background removal filter enhance the “archaeological” structure a little (Fig. 2e). The removal of an average trace of 1 m length (Fig. 2f) suppresses more horizontal patterns than the background filter, but it also changes the hyperbolas of the archaeological structures.

Figure 2: Part of the prospection of the Roman villa Zillingtal, depth slice 1,00-1,10 m.

Figure 2: Part of the prospection of the Roman villa Zillingtal, depth slice 1,00-1,10 m.

a) without special pre-processing; b) ) removing frequencies below 225 MHz and background removal filter; c) band-pass filtering (500-1000 MHz) and background removal filter; d) band-pass filtering (500-1000 MHz) and removal of average trace of 1 m length.

Roman Villa Zillingtal

5The Roman villa of Zillingtal was prospected in April 2006 and February 2008 covering an area of 14.175 m2 with a Sensor and Software Noggin System and a PulseEKKO Pro, both with 500 MHz antennas. The survey grid was 50 x 2.5 cm. Both systems produce very small instrument noise, but the data suffer from tractor traces (in the middle area of Fig 3a) and ploughing areas (in the very south and east of Fig. 3a). Visualizing the data using high-pass filtering (frequencies above 250 MHz) and background removal filter (Fig. 3b) leads to much better results, but again a band-pass filter (500 MHz-1000 MHz) enhances the signal to noise ratio (Fig. 3c) and a removal of the average trace of a 1 m window widens the archaeological structures, but remove the line patterns produced by tractor wheels.

Figure 3: Part of the prospection of the Roman villa Zillingtal, depth slice 1.00-1.10 m.

Figure 3: Part of the prospection of the Roman villa Zillingtal, depth slice 1.00-1.10 m.

a) without special pre-processing; b) removing frequencies below 225 MHz and background removal filter; c) band-pass filtering (500-1000 MHz) and background removal filter; d) band-pass filtering (500-1000 MHz) and removal of average trace of 1 m length.

Roman Villa Antau

6The Roman villa of Antau was prospected in April 2006 using a Noggin system and in February 2008 using a PulseEKKO Pro system, both with 250 MHz antennas. An area of 11.500 m2 was prospected with a spatial grid of 0.5 x 0.05 m. These data also suffer from irregular surface conditions. Again a band-pass-filter (500 MHz-1000 MHz) together with a background removal filter produces much better visualizations of the archaeological structure compared to unfiltered data. These data show that the enhancement can vary within the depth and depends also on the instrument. While very good enhancements can be seen in all depths for the Noggin system, the PulseEKKO Pro system has few enhancements in the depth of 0.80-0.90 m, little enhancements in the depth above (0.50-0.60 m) and very good enhancement in the depth below (1.10-1.20 m and 1.40-1.50 m).

Conclusion

7Depending on the GPR system, the antenna frequency and the surface conditions of the site, suitable band filtering and average trace removal filters with adapted length can not only improve the signal-to-noise ratio, but also enhance the visualisation of depth slices and can even make visible archaeological structures which are invisible without this special processing. Three different sites of Roman villas in Austria were prospected with different GPR systems and antenna frequencies and require suitable processing to get the best results.

Top of page

Appendix

Daim, F., Doneus, N, Neubauer, W. and Scharrer, G., 2001. The Halbturn Project: A rural Roman settlement and cemetery in Burgenland, Austria. In Doneus et al., (dir.). Archaeological Prospection, 4th Int. Conference Vienna 2001, 87-89.

Seren, S., Eder-Hinterleitner, A., Neubauer, W., Löcker, K. and Melichar, P., 2007. Extended comparison of different GPR systems and antenna configurations at the Roman site Carnuntum, Near Surface Geophysics, 5 (6): 389-394.

Top of page

List of illustrations

Title Figure 1a-f: Visualisation of a part of corresponding radargram (length: 14 m; time: 30 ns).
Caption a) without special pre-processing; b-f): removing erroneous traces; b) removing frequencies below 450 MHz; c) background removal filter; d) removing frequencies below 450 MHz and background removal filter; e) band pass filter (900 MHz-1800 MHz) and background removal filter; f) band pass filter (900 MHz-1800 MHz) and removal of average trace of 1m length.
URL http://journals.openedition.org/archeosciences/docannexe/image/1741/img-1.jpg
File image/jpeg, 816k
Title Figure 2: Part of the prospection of the Roman villa Zillingtal, depth slice 1,00-1,10 m.
Caption a) without special pre-processing; b) ) removing frequencies below 225 MHz and background removal filter; c) band-pass filtering (500-1000 MHz) and background removal filter; d) band-pass filtering (500-1000 MHz) and removal of average trace of 1 m length.
URL http://journals.openedition.org/archeosciences/docannexe/image/1741/img-2.jpg
File image/jpeg, 500k
Title Figure 3: Part of the prospection of the Roman villa Zillingtal, depth slice 1.00-1.10 m.
Caption a) without special pre-processing; b) removing frequencies below 225 MHz and background removal filter; c) band-pass filtering (500-1000 MHz) and background removal filter; d) band-pass filtering (500-1000 MHz) and removal of average trace of 1 m length.
URL http://journals.openedition.org/archeosciences/docannexe/image/1741/img-3.jpg
File image/jpeg, 458k
Top of page

References

Bibliographical reference

Alois Hinterleitner, S. Seren, Klaus Löcker, Wolfgang Neubauer and E. Bayirli, “Data Processing and Image Enhancement of GPR Surveys of Roman Villas in Austria”ArcheoSciences, 33 (suppl.) | 2009, 299-302.

Electronic reference

Alois Hinterleitner, S. Seren, Klaus Löcker, Wolfgang Neubauer and E. Bayirli, “Data Processing and Image Enhancement of GPR Surveys of Roman Villas in Austria”ArcheoSciences [Online], 33 (suppl.) | 2009, Online since 30 October 2011, connection on 29 January 2022. URL: http://journals.openedition.org/archeosciences/1741; DOI: https://doi.org/10.4000/archeosciences.1741

Top of page

About the authors

Alois Hinterleitner

Central Institute for Meteorology and Geodynamics, Hohe Warte 38, A- 1190 Vienna, Austria (Alois.Hinterleitner@zamg.ac.at)

By this author

S. Seren

Central Institute for Meteorology and Geodynamics, Hohe Warte 38, A- 1190 Vienna, Austria

By this author

Klaus Löcker

Central Institute for Meteorology and Geodynamics, Hohe Warte 38, A- 1190 Vienna, Austria

By this author

Wolfgang Neubauer

Vienna Institute for Archaeological Science, University of Vienna, Franz Klein-Gasse 1/V, A-1190 Vienna, Austria

By this author

E. Bayirli

Central Institute for Meteorology and Geodynamics, Hohe Warte 38, A- 1190 Vienna, Austria

Top of page

Copyright

Tous droits réservés

Top of page
Search OpenEdition Search

You will be redirected to OpenEdition Search